![]()
If you have black bars and printer is not detected properly, it means you did not do the point 4 properly ( #172) so go back to point 4. If done correctly you will see the arduino sketch compile successfully and output in the log showing the upload status. Press the usual arduino compile and upload button.NOTE: You can usually find this out by looking at the tools -> port menu both before and after plugging in the printer to your computer's USB. Under the tools menu select the board type as Arduino DUE (Native USB Port) and the proper port you have connected to the printer.Modify the DAVINCI define in Configuration.h file to match your targeted Da Vinci.Open the project file named repetier.ino located in src\ArduinoDUE\Repetier directory in the arduino IDE.NOTE: You do not need to compile arduino from source these files are in the arduino directory structure FAQ#114. REPETIER SERVER MANUAL PDF UPDATEUpdate variants.cpp/USBCore.cpp arduino files with the ones present in src\ArduinoDUE\AdditionalArduinoFile according your IDE version.Do not use 1.5.8 it is not supported and will give compilation error: FAQ#201 Use an arduino IDE supporting arduino DUE, 1.8.0 with Due 1.6.8 module from board manager FAQ#166.Note 2: remove the jumper before flashing if still there Note : points 1 and 2 are only needed to wipe the stock fw or a corrupted fw, for update they are not necessary. REPETIER SERVER MANUAL PDF INSTALLNOTE: Windows users may need to install drivers to detect the board. The machine will have been flashed removing the current stock firmware and allowing it to be detected as a normal arduino DUE.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |